Reference

Filter

The filter section consists of 7 knobs and a button.

Cutoff

Controls the filter cut-off frequency (in Hz).

Q

Controls the filter resonance.

Type

Allows you to smoothly change between the following filter types:

Thru - no filtering
Low - lowpass filter
Band - bandpass filter
High - highpass filter

LFO Speed

Controls the speed of the filter LFO (in Hz), which modulates the cutoff frequency.

LFO Depth

Controls the depth of the filter LFO. The value is a number of octaves to sweep the cutoff frequency by.

Saturate

The small button above the 'Saturation' control turns the saturation effect on and off. NB when this is turned off, the signal in the loop can reach very high levels which may cause problems further down the line.

Saturation

Controls the level of saturation (overdrive) applied to the signal (before being fed into the filter).

Saturation Shape

Controls the shape of the saturation. At '1.0' the effect is that of soft saturation and clipping. At '0.0' the effect is of hard digital clipping. Note that at shape settings other than '0.0', some alteration is applied to the signal even if the Saturation level is zero.